Removal And Installation

COIL SPRING

Removal and Installation


REMOVAL

1.Remove tires with power tool. Removal And Installation.





2.Set jack under rear suspension beam.

CAUTION:
- Never damage the suspension beam with a jack.
- Check the stable condition when using a jack.
3.Remove rear shock absorber mounting bolts (lower side). Exploded View.
4.Slowly lower jack, then remove upper rubber seat, coil spring and lower rubber seat from rear suspension beam.

CAUTION:
Operate while checking that jack supporting status is stable.
5.Perform inspection after removal. Inspection.

INSTALLATION

Note the following, and install in the reverse order of removal.





- Install lower rubber seat with its protrusion (A) on the lower area aligned with the hole of rear suspension beam.

B : Coil spring lower end

- Securely install coil spring with the lower end of the major diameter aligned with the steps of lower rubber seat.
- Perform inspection after installation. Inspection.