Ignition Switch

IGNITION & KEY ALARM SWITCH ASM

Remove or Disconnect

1. Do all steps, "Remove or Disconnect", UPPER COVER LOWER COVER.Service and Repair

Fig. 6 Ignition & Key Alarm Switch Removal:

2. Two wire straps from steering column wire harness.
3. Steering column bulkhead connector from vehicle wire harness.
4. Ignition & key alarm switch assembly wire harness from wire harness strap.
5. Grey and black connectors of turn signal & multifunction switch from column bulkhead connector.
6. Two tapping screws.
7. Ignition switch assembly.

Install or Connect

1. Ignition & key alarm switch assembly.
2. Two tapping screws.

Tighten
^ Tighten screws to 1.4 Nm (12 lb.in.).

3. Grey and black connectors of turn signal & multifuntion switch to column bulkhead connector.
4. Wire harness to wire harness strap.
5. Steering column bulkhead connector to vehicle wire harness.
6. Two wire straps to steering column wire harness.
7. Do all steps, "Install or Connect", UPPER COVER LOWER COVER.