Engine Mount Replacement

REMOVAL PROCEDURE

^ Tools Required
- J 28467-A Engine Support Fixture





1. Install the J28467-A.
2. Install the front core support adapter.
3. Install the engine core support bar.
4. Install the engine support fixture adapter.
5. Remove the windshield washer reservoir.
6. Detach the engine compartment positive battery junction block and move aside.





7. Remove the mount to body through bolt.
8. Remove the torque axis mount from the engine mount bracket.
9. Raise the vehicle.
10. Remove the right front wheel/tire assembly.
11. Remove the splash shield from the wheel well.
12. Remove the lower center air deflector.
13. Remove the left transaxle mount to frame through bolt.
14. Remove the lower retaining bolt and nut from the engine mount bracket.
15. Disconnect the power steering line retainer from the bracket.
16. Lower the vehicle.
17. Remove the upper retaining bolt and nut from the engine mount bracket.
18. Release the drive belt tensioner.
19. Remove the belt from the power steering pump.





20. Remove the intake sight shield.
21. Remove the power steering pump. Set the pump aside.
22. Raise the engine at the support fixture.





23. Remove the engine mount bracket from the engine.
24. Remove the torque axis mount from the body.

INSTALLATION PROCEDURE

^ Tools Required
- J 28467-A Engine Support Fixture





1. Install the torque axis mount into the body.
2. Install the engine mount bracket to the engine.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the engine mount bracket to engine nuts and bolts.
^ Tighten the mount bracket to engine nuts to 40 Nm (30 ft. lbs.).
^ Tighten the mount bracket to engine bolts to 55 Nm (41 ft. lbs.).

4. Lower the engine at the support fixture.
5. Install the power steering pump.
^ Tighten the power steering pump to 50 Nm (37 ft. lbs.).

6. Raise the vehicle.





7. Install the left transaxle mount to frame through bolt.
8. Install the lower center air deflector.
9. Install the splash shield to the wheel well.
10. Install the wheel/tire assembly.
11. Lower the vehicle.
12. Install the torque axis mount to the engine mount bracket.
13. Install the torque axis mount to the engine mount bracket bolt.
^ Tighten the mount to engine bracket bolt to 95 Nm (70 ft. lbs.).





14. Install the mount to body through bolt.
^ Tighten the mount to body through bolt to 50 Nm (37 ft. lbs.).

15. Remove the J28467-A.