Diesel Data: Automotive Repair

Installation Procedure

1. Install the generator through the top left side of the engine compartment.

2. Connect the power steering hose to the reservoir.

3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

Notice:
Refer to Fastener Notice in Cautions and Notices.





4. Install the generator mounting studs and nuts.
Tighten
Tighten the lower generator bracket to block nuts to 38 Nm (28 lb ft).

5. Install the generator mounting bolts.
Tighten
Tighten the generator mounting bolts to 50 Nm (37 lb ft).

6. Install the lower splash shield.

7. Lower the vehicle.

8. Connect the electrical connector.





9. Install the accessory drive belt. Refer to Drive Belt Replacement in Engine Mechanical.

10. Install the radiator. Refer to Radiator Replacement in Engine Cooling.

11. Install the upper radiator shroud.

12. Install the air inlet duct.

13. Connect the negative battery cable.

14. Install the rear seat cushion. Refer to Seat Cushion Replacement - Rear in Seats.