Washer Solvent Container Replacement (Outer)

REMOVAL PROCEDURE
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the RH front wheelhouse panel from the vehicle.
3. Disconnect the transfer hose from the washer solvent container.
3.1. Slide the clamp down the transfer hose away from the washer solvent container.
3.2. Pull the transfer hose from the washer solvent container.
4. Cut two pieces of tape where the tape crosses the harness and the hose. Pull the tape away from the harness and the hose.
5. Remove two screws and the washer solvent container from the vehicle.
6. Disconnect the hose from the top of the washer solvent container.
7. Disconnect the hose from the washer pump.
8. Disconnect the harness connector from the washer pump.
9. Disconnect harness connector from the level sensor.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Cautions and Notices.

1. Connect the harness connector to the level sensor.
2. Connect the harness connector to the washer pump.
3. Connect the hose to the washer pump.
4. Connect the hose to the top of the washer solvent container.
5. Tape the hose and the harness to the washer solvent container with electrical tape.
6. Install the washer solvent container onto the vehicle with two screws.

Tighten
Tighten two screws to 5 N.m (44 lb in).

7. Connect the transfer hose onto the washer solvent container with the clamp.
8. Install the RH front wheelhouse panel.
9. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.