Water Pump Replacement

^ Tools Required
- J 36660 Torque Angle Meter





1. Partially drain the engine coolant from the cooling system.
2. Loosen the water pump pulley bolts.
3. Remove the drive belt.
4. Remove the water pump pulley bolts.
5. Remove the water pump pulley.
6. Position aside the power steering pump.





7. Remove the water pump bolts.





8. Remove the water pump.
9. Remove the water pump gasket.
10. Clean and inspect the water pump mating surfaces.


INSTALLATION PROCEDURE





1. Install the water pump gasket.
2. Install the water pump.





Notice: Refer to Fastener Notice in Service Precautions.

3. Use the J 36660 in order to install the water pump bolts.
^ Tighten the long water pump bolts to 20 Nm (15 ft. lbs.) plus 40°
^ Tighten the short water pump bolts to 15 Nm (11 ft. lbs.) plus 80°.





4. Install the water pump pulley.
5. Loosely install the water pump pulley bolts.
6. Install the power steering pump.
7. Install the drive belt.
8. Tighten the water pump pulley bolts.
^ Tighten the bolts to 13 Nm (115 inch lbs.)
9. Fill the engine cooling system with engine coolant.
10. Inspect for leaks.