Exhaust Muffler Hangers Replacement (Center)

REMOVAL PROCEDURE





1. Raise and suitably support the vehicle.

Notice: To prevent internal damage to the flexible coupling of the catalytic converter assembly, the converter must be supported. The vertical movement at the rear of the catalytic converter assembly must not exceed 6° up or down.

2. Suitably support the exhaust system.
3. Remove the exhaust pipe rear hanger insulator.





4. Inspect the exhaust pipe rear hanger bracket for serviceability. Repair or replace as necessary.
5. Remove the exhaust pipe rear hanger bolt.
6. Remove the exhaust pipe rear hanger bracket.


INSTALLATION PROCEDURE





1. Replace the exhaust pipe rear hanger bracket if removed.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the exhaust pipe rear hanger bolt.
^ Tighten the exhaust pipe rear hanger bolt to 25 Nm (18 ft. lbs.).





3. Install the exhaust pipe rear hanger insulator.
4. Remove the support from the exhaust system.
5. Lower the vehicle.
6. Inspect the exhaust system for leaks and underbody contact.