Accelerator Controls Cable Bracket Replacement

REMOVAL PROCEDURE




1. Remove the fuel injector sight shield.




2. Rotate the throttle lever.
3. Disconnect the cruise control cable (1) from the bracket (2).




4. Disconnect the accelerator cable (2) from the bracket (1).




5. Remove the wiring harness clip (1) from bracket (3).




6. Remove the 2 bolts from the bracket.

INSTALLATION PROCEDURE





NOTE:
^ Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.
^ Refer to Fastener Notice in Service Precautions.

1. Install the 2 brackets bolts.

Tighten
Tighten the bolts to 16 N.m (142 lb in)




2. Connect wiring harness clip (1) to the bracket (3).




3. Connect the accelerator cable (2) to the bracket (1).




4. Connect the cruise control cable (1) to the bracket (2).





IMPORTANT: The throttle should operate freely, without binding, between full closed and wide open throttle.

5. Test for complete throttle opening and closing by operating the accelerator pedal. Also inspect for proper carpet fit under the accelerator pedal.
6. Reinstall the fuel injection sight shield.