Pulley Removal and Installation

REMOVAL PROCEDURE

- Tools Required
- J 25034-C Power Steering Pump Pulley Remover (Base Only)
- J 37609 Screw
- J 25033-C Power Steering Pump Pulley Installer
OR
- J 37609-A Power Steering Pump Pulley Remover
- J 36015 Power Steering Pump Pulley Installer





1. Remove the accessary drive belt. Refer to Drive Belt Replacement in Engine.
2. Remove the power steering pump from the engine for clearance. Refer to Power Steering Pump Replacement.
3. Use the J 25034-C and the J 37609 or the J 37609-A in order to remove the pump pulley.

INSTALLATION PROCEDURE

- Tools Required
- J 25033-C Power Steering Pump Pulley Installer
- J 36015 Power Steering Pump Pulley Installer

NOTICE: Refer to Fastener Notice in Service Precautions.

IMPORTANT:
- The face of the pulley hub must be flush with the end of the power steering pump driveshaft.
- Do not use the arbor press to install the power steering pump pulley.





1. Use the J 25033-C or the J 36015 in order to install the power steering pump pulley.
2. Install the power steering pump to the engine. Refer to Power Steering Pump Replacement.
3. Install the accessary drive belt. Refer to Drive Belt Replacement in Engine.
4. Bleed the power steering system. Refer to Bleeding Power Steering System.
5. Inspect the power steering system for leaks. Refer to Power Steering Gear and Pump Leaks.