Tie Rod End Replacement - Outer (Off Vehicle)

DISASSEMBLY PROCEDURE

- Tools Required
- J 24319-01 Universal Steering Linkage Puller





1. Pull the prevailing torque nut (2) from outer tie rod assembly (1).





2. Loosen the jam nut (2) on the inner tie rod assembly (1).





3. Remove the outer tie rod assembly (2) from the steering knuckle (1) using J 24319-01.





4. Remove the outer tie rod assembly (3) from the inner tie rod assembly (1).

ASSEMBLY PROCEDURE





1. Connect the outer tie rod assembly (3) to the inner tie rod (1).
2. Do not tighten the jam nut (2).





3. Connect the outer tie rod assembly (2) to the steering knuckle (1).





4. Connect the prevailing torque nut (2) to the outer tie rod stud (1).
- Tighten the prevailing torque nut (2) to 25 Nm (18 ft. lbs.). Tighten the prevailing torque nut (2) an additional 180 degrees of rotation.

IMPORTANT: Be sure the rack and pinion boot is not twisted or puckered during toe adjustment.

5. Adjust toe by turning the inner tie rod. Follow the recommended manufacturer specifications; refer to Front Toe Adjustment.
- Tighten the jam nut against the outer tie rod to 68 Nm (50 ft. lbs.).