Windshield Washer Reservoir: Service and Repair

REMOVAL PROCEDURE



1. Remove the retainer from the tube and the vehicle.
2. Remove the tube with the seal from the washer solvent container.
3. Remove the seal from the tube.




4. Raise the vehicle.
5. Remove the wheel.
6. Remove the inner fender liner.
7. Remove the connector and the hose from the washer pump.
8. Remove three screws and the washer solvent container from the vehicle (the washer solvent level sensor is still connected).
9. Remove the connector from the washer solvent level sensor.
10. Remove two screws and the bracket from the washer solvent container.
11. Remove the solvent level sensor from the washer solvent container.
12. Remove the solvent level sensor seal from the washer solvent container.
13. Remove the washer pump and seal.

INSTALLATION PROCEDURE



1. Install the washer pump and the seal.
2. Install the solvent level sensor seal on the washer solvent container.
3. Install solvent level sensor on the solvent container.

NOTE: Refer to Fastener Notice.

4. Install the bracket with two screws on the washer solvent container.

Tighten
Tighten the screws to 7 N.m (62 lb in).

5. Install the connector onto washer solvent level sensor.

NOTE: Refer to Fastener Notice.

6. Install the washer solvent container on the vehicle with three screws.

Tighten
Tighten the screws to 5 N.m (44 lb in).

7. Install the connector and the hose to the washer pump.
8. Install the inner fender liner.
9. Install the wheel.
10. Lower the vehicle.




11. Install the seal onto the tube.
12. Install the tube with the seal on the washer solvent container.

NOTE: Refer to Fastener Notice.

13. Install the tube on the vehicle with the screw.

Tighten
Tighten the screw to 5 N.m (44 lb in).