Enabling

1. Remove the key from the ignition switch.
2. Connect the passenger side air bag yellow connector (1) to vehicle harness yellow connector (4) located under the passenger seat.
3. Install the connector position assurance (CPA) to the passenger side air bag yellow connector (4).
4. Connect the driver side air bag yellow connector (1) to vehicle harness yellow connector (4) located under the driver seat.
5. Install the connector position assurance (CPA) to the driver side air bag yellow connector (4).




6. Connect the passenger (IP) frontal air bag yellow connector (2) to the vehicle harness yellow connector (1) located above the passenger sound insulator.
7. Install the connector position assurance (CPA) (4) to the passenger yellow connector (1).
8. Install the passenger sound insulator.




9. Connect the driver frontal air bag yellow connector (4) to the vehicle harness yellow connector (3) located next to steering column (2).
10. Install the connector position assurance (CPA) (1) to the driver yellow connector (3).
11. Install the driver sound insulator.




12. Rear fuse block is located under the rear seat.
13. Install the SIR fuse to the rear fuse block.
14. Staying well away from all air bags, turn the ignition switch to the ON position.
14.1. The AIR BAG warning lamp will flash 7 times.
14.2. The AIR BAG warning lamp will then turn OFF.
15. Perform the SIR Diagnostic System Check if the AIR BAG warning lamp does not operate as described. Refer to Diagnostic System Check - SIR. Diagnostic System Check