Turn Signal Flasher: Service and Repair

HAZARD AND TURN SIGNAL FLASHER REPLACEMENT

REMOVAL PROCEDURE




1. Remove the left knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gauges and Warning Indicators.
2. Remove the hazard and turn signal flasher module (1) from the i/IP carrier.
3. Disconnect the electrical connector.

INSTALLATION PROCEDURE




1. Connect the electrical connector.
2. Install the hazard and turn signal flasher module (1) to the I/IP carrier.
3. Install the left knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gauges and Warning Indicators.