Discharge Hose Replacement
DISCHARGE HOSE REPLACEMENTTOOLS REQUIRED
J 39400-A Halogen Leak Detector
REMOVE PROCEDURE
1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
2. Remove the nut (1) and discharge hose from the condenser.
3. Raise and support vehicle. Refer to Lifting and Jacking the Vehicle
4. Remove the lower radiator air deflector. Refer to Air Deflector Replacement - Front in Body Front End.
5. Disconnect the electrical connector from the A/C refrigerant pressure sensor (1).
6. Disconnect the discharge hose (3) from the compressor and remove.
7. Remove the discharge hose.
INSTALLATION PROCEDURE
IMPORTANT: Inspect the seal washers for damage before reinstalling the A/C lines and hoses.
If any damage is noted during inspection, the suspect seal must be replaced.
Flat washer type seals do not require lubrication.
1. Position the discharge hose into the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the discharge hose (3) and nut (2) to the compressor.
Tighten
Tighten the nut to 20 N.m (15 lb ft).
3. Connect the electrical connector to the A/C refrigerant pressure sensor (1).
4. Lower the vehicle.
5. Install the discharge hose nut (1) to the condenser.
Tighten
Tighten the nut to 20 N.m (15 lb ft).
6. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
7. Leak test the fittings of the component using the J 39400-A.
8. Install the front air deflector. Refer to Air Deflector Replacement - Front in Body Front End.