Evaporative Emission Control Canister: Service and Repair

EVAPORATIVE EMISSION (EVAP) CANISTER REPLACEMENT

REMOVAL PROCEDURE




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect EVAP purge pipe (3), vapor pipe (2) and vent hose/pipe (1) from the EVAP canister.




3. Remove the EVAP canister bracket retaining nuts (2).
4. Remove the canister (1) from the EVAP canister bracket (3).

INSTALLATION PROCEDURE




1. Install the EVAP canister (1) to the EVAP canister bracket (3) and position the canister on the underbody.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the EVAP canister bracket retaining nuts (2).

Tighten
Tighten the nuts to 6 N.m (53 lb in).




3. Connect the EVAP purge pipe (3), vapor pipe (2) and vent hose/pipe (1) to the EVAP canister.
4. Lower the vehicle.