Diesel Data: Automotive Repair
Home >> Oldsmobile >> 2001 >> Aurora V8-4.0L VIN C >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Air Bag >> Service and Repair >> Inflatable Restraint Steering Wheel Module Replacement

Inflatable Restraint Steering Wheel Module Replacement

TOOLS REQUIRED
J 44298 Driver Air Bag Removal Tool

REMOVAL PROCEDURE

CAUTION:
^ Refer to SIR Inflator Module Handling And Storage Caution in Service Precautions.
^ A deployed dual stage inflator module will look the same whether one or both stages were used, always assume a deployed dual stage inflator module has an active stage 2. Improper handling or servicing can activate the inflator module and cause personal injury. Refer to SIR Inflator Module Handling and Storage Caution.




1. Disable the SIR system.

2. On back side of steering wheel there are four openings/holes for removing the steering wheel module.
3. Position the steering wheel so that 2 of the opening/holes are on top.
4. Adjust and install J 44298 into 2 of the holes.

IMPORTANT: Air bag removal tool must be seated all the way in to perform properly.

5. Push the handle back towards instrument panel (IP) releasing the 2 spring loaded fasteners at the same time.
6. Turn the steering wheel and open air bag tool, use one of the tool fingers to remove cruise control lever cover in order to gain access.
7. Position air bag removal tool and insent into place around cruise control lever and repeat the same steps that were used on other 2 opening/holes.
8. Pull the inflatable restraint steering wheel module gently away from the steering wheel.

IMPORTANT: Note the steering wheel module connector (or connectors if equipped with dual stage air bags) wire routing positions, the redundant control routing positions, and the horn wire routing positions for the correct re-assembly.




9. Remove the connector position assurance (CPA) (4) and steering wheel module electrical connector.
10. Remove the horn grounded lead (2) from the threaded hole in the steering wheel.
11. Rotate the horn contact lead counterclockwise 1/4 turn.
12. Remove the horn contact lead (2) from the steering column cam tower.
13. Remove the steering wheel module (5).

INSTALLATION PROCEDURE




1. Connect the horn ground lead (2) into the lower left threaded hole in the steering wheel.
2. Connect the horn contact lead into the steering column cam tower.
3. Rotate the horn contact 1/4 turn clockwise to lock.
4. Connect the steering wheel module electrical connector and CPA (4).

IMPORTANT: If vehicle is equipped with dual stage air bags then there will be 2 connectors, match the right color connector to the right color opening in module. Route the steering wheel module wires, the redundant control wires, and the horn wires correctly.

5. Align the steering wheel module fasteners to the steering column fastener holes.
6. Push the steering wheel module firmly into the steering column in order that the fasteners engage.

IMPORTANT: After replacing a deployed or undeployed dual stage inflator module, correct disposal is required. A deployed dual stage inflator module must be energized to ensure that both stages are no longer active. Refer to Inflator Module Handling and Scrapping for proper disposal.

7. Enable the SIR system.
Diesel-Data.com