Turn Signal & Multifunction Switch

Turn Signal and Multifunction Switch Assembly-Disassemble-Off Vehicle
1. Remove the upper and lower trim covers. Remove the wire harness straps.





2. Remove the wire harness assembly from the wire restraint clip (1).
3. Disconnect the connectors of the turn signal and multifunction switch assembly.





4. Remove 2 pan head tapping screws from the turn signal and multifunction switch assembly.
5. Remove the turn signal and multifunction switch assembly.

Turn Signal and Multifunction Switch Assembly-Assemble-Off Vehicle

Important: The electrical contact on the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.

1. Install the turn signal and multifunction switch assembly.

Notice: Refer to Fastener Notice in Service Precautions.





2. Secure by using 2 pan head tapping screws.
- Tighten the screws to 7 Nm (62 inch lbs.).





3. Reconnect the connectors of the turn signal and multifunction switch assembly.

Important: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil causing an inflatable restraint malfunction.

4. Install the wire harness straps.
5. Install the wire harness assembly into the wire restraint clip (1).
6. Install the upper and lower trim covers.