4T65-E

Fluid Filler Tube Replacement

Removal Procedure





1. Remove the fluid indicator.
2. Raise the vehicle. Refer to Vehicle Lifting.
3. Remove the fluid filler tube bracket bolt from the fluid filler tube bracket.
4. Remove the fluid filler tube.
5. Remove filler tube seal.

Installation Procedure

Important Do NOT place the fluid filler tube seal on the fluid filler tube when installing the tube or damage to the seal will result.





1. Install the fluid filler tube seal in the transaxle.
2. Apply some DEXRON (R)III fluid or equivalent to the inside diameter of the seal.
3. Lower the vehicle. Refer to Vehicle Lifting.
4. Position the fluid filler tube into the transaxle.

Notice: Refer to Fastener Notice in Service Precautions.

5. Install the fluid filler tube bracket bolt through the fluid filler tube bracket.
^ Tighten the fluid filler tube bracket bolt to 9 Nm (79 inch lbs.).
6. Install the indicator.
7. Adjust the fluid level.
8. Inspect for proper fluid level.
9. Inspect for fluid leaks.