Diesel Data: Automotive Repair

Pressure

Power Steering Pressure Hose Replacement

Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the power steering gear heat shield.





3. Remove the power steering pressure hose retainer (2) from the engine frame at gear.
4. Remove the power steering pressure hose from the power steering gear.





5. Remove the power steering pressure hose retaining nut from the cylinder head.
6. Lower the vehicle.
7. Disconnect the power steering pressure hose at the power steering pump.
8. Remove the power steering pressure hose from the vehicle.

Installation Procedure





1. Install the power steering pressure hose to the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the power steering pressure hose to the power steering pump.
Tighten the power steering pressure hose to the power steering pump to 30 Nm (22 ft. lbs.).
3. Install the power steering pressure hose bracket and retaining nut to the cylinder head.
Tighten the power steering pressure hose retaining nut to 8 Nm (71 inch lbs.).
4. Raise the vehicle.





5. Install the power steering pressure hose to the retainer (2).
6. Install the power steering pressure hose (1) to the power steering gear.
Tighten the power steering pressure hose to the power steering gear to 30 Nm (22 ft. lbs.).
7. Install the power steering gear heat shield.
8. Lower the vehicle.
9. Bleed the power steering system.