Wheel Bearing/Hub Replacement - Rear

Wheel Bearing/Hub Replacement - Rear

Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the brake rotor.





3. Remove the ABS sensor harness connector.
4. Remove the 4 bolts from the control arm.
5. Remove the hub and bearing from the control arm.
6. Remove the brake shield from the control arm.
7. Clean the control arm face and the bore before installing the hub and the bearing.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the brake shield and the hub and the bearing to the control arm with the 4 bolts.
Tighten the hub and bearing bolts to 70 Nm (52 ft. lbs.).
2. Connect the ABS sensor harness connector.
3. Install the brake rotor.
4. Install the tire and wheel.
5. Lower the vehicle.