6D Throttle Position Wires to Logic Module

1. With ignition switch in Off position, disconnect logic module white and black electrical connector.
2. Connect an ohmmeter between black electrical connector terminal No. 1 and white electrical connector terminal No. 25.
3. If resistance is indicated, replace logic module.
CAUTION: Before replacing the logic module make sure the terminals in cavities No. 1 and 25 of the logic module connectors are not crushed so that they cannot touch the logic module pins.
4. If resistance is not indicated, check wiring for an open circuit between logic module white electrical connector terminal No. 25 and throttle position sensor electrical connector.