Distance Sensor - Intermittent Engine Surge/Buck

88chrysler17

Models


1988 M-Body "E" Price Class Vehicles Only (Number "1" In The Sixth Position Of The VIN)


Subject

Intermittent Surge or Buck at Low Speeds


Index

DRIVEABILITY


Date

July 5, 1988


No.

18-13-88

P-2611

(C18-15)

CAUTION: THIS BULLETIN ONLY APPLIES TO A LIMITED NUMBER OF DIPLOMAT AND GRAN FURY VEHICLES ONLY.

SYMPTOM/CONDITION

Intermittent buck or surge during light acceleration, vehicle may also experience die-out during deceleration at slow speeds.

DIAGNOSIS

If the vehicle has not had this filter jumper harness installed, continue with the repair procedure.

PARTS REQUIRED

NOTE: THIS HARNESS WILL FIT ONLY "E" PRICE CLASS VEHICLES, IT WILL NOT FIT A FIFTH AVENUE.

1 Filter Jumper Harness P/N 4414708
1 Authorized Modification Label P/N 4275086

REPAIR PROCEDURE

This repair involves the installation on a filter jumper harness into the distance sensor wiring.

1. Locate the two wire connector near the rear of the passenger side engine valve cover (white wire with orange tracer and black wire with light blue tracer).

2. Separate this connector, and install the filter jumper harness.

3. Type "Filter Jumper Harness, P/N 4414708 Installed" on the Authorized Modification Label, and attach near the VECI label.

POLICY: Reimbursable within the provisions of the warranty


TIME ALLOWANCE:
Labor Operation No. 08-45-13-90 . . . . . . . . . . 0.2 Hrs.


FAILURE CODE: 15 - Calibration