Ignition Timing: Adjustments

Before checking or adjusting ignition timing, be sure:
Engine coolant temperature is at operating temperature, 85-95°C (185 - 195°F)
Lights, electrical accessories, and cooling fan are OFF
Transaxle is in Park or Neutral
Front wheels are pointing straight ahead
Parking brake is set

1. Connect a timing light to the number one cylinder according to manufacturers instructions.

Ignition Timing Adjustment:

2. Connect a tachometer. If using a primary current pulse detection type tachometer, insert a paper clip into the back side of the tachometer harness connector, then connect a tachometer to the paper clip.
DO NOT disconnect the electrical connector.
3. Start and run the engine at idle. Verify the idle speed is at CURB Idle.
Refer to MECHANICAL SPECIFICATIONS.

Ignition Timing Adjustment:

4. With the engine stopped, disconnect the ignition timing adjustment terminal, located in the engine compartment. Ground the terminal using a lead wire with alligator clips.
5. Restart the engine.

Timing Mark:

6. Aim the timing light at the timing mark and check BASIC ignition timing.
Refer to ELECTRICAL SPECIFICATIONS.

Basic Ignition Timing Adjustment:

7. If timing is not within specification, loosen the distributor mounting nut and adjust by turning the distributor housing.
After adjustment, tighten the nut being careful that the distributor does not move.
8. Stop the engine. Disconnect the lead wire from the ignition timing adjustment connector and remove the tachometer and the paper clip.
9. Start and run the engine at idle.
10. Recheck ignition timing to ensure that it advances from BASIC to ACTUAL timing.
Refer to ELECTRICAL SPECIFICATIONS.
11. Remove the ignition timing light.

NOTE:
(a) Actual ignition timing may vary, depending on the control mode of the MPI Control Unit.

(B) At altitudes more than 700 meters (2,300 feet) above sea level, the MPI Control Unit may further advance the actual ignition timing.