Front Door Window Regulator

REMOVAL STEPS
1. Door trim and waterproof film
2. Door mirror cover
3. Delta pad
4. Door mirror
5. Outer weatherstrip
6. Door glass holder
7. Door glass pad
8. Door window glass
9. Window regulator

NOTES:
1. Reverse the removal procedures to reinstall.
2. * Vehicles with a power window

SERVICE POINTS OF REMOVAL





5. Removal Of Outer Weatherstrip
Use a screwdriver or a similar tool to remove the outer weatherstrip.





8. Removal Of Door Window Glass
1. Lower the door glass to the access hole position.
2. Remove the door glass mounting bolts from the door glass holder.

NOTE: When removing the door glass mounting bolts, support the glass to avoid dropping it.





3. Remove the door glass by lifting it upward.

9. Removal Of Window Regulator





Vehicles without a Power Window
1. Remove the window regulator mounting bolts.

NOTE: Hold the regulator assembly so that it does not drop off when bolts are removed.

2. Take out the window regulator through the access hole.





Vehicles with a Power Window
1. Remove the regulator mounting bolts, and then remove the regulator from the access hole.
2. Disconnect the power window motor from the regulator.

CAUTION: Because the force of the regulator spring may cause the regulator arm to jump up when the screws attaching the motor to the window regulator are removed, remove the regulator spring before removing the screws.

SERVICE POINTS OF INSTALLATION





9. Installation Of Window Regulator
Vehicles without a Power Window
Apply a coating of chassis grease to the sliding parts and rotating parts of the window regulator.





Vehicles with a Power Window
When assembling the window regulator and power window motor. first install the regulator spring. and then proceed with assembly.





8. Installation Of Door Window Glass
When the door glass has been removed from the glass holder. install to the position shown in illustration.

Standard value: 106-113 mm (4.17-4.45 in.)