Rear Door Window Regulator

REMOVAL STEPS
1. Door trim and waterproof film
2. Outer weatherstrip
3. Door window glass mounting bolts
4. Door center sash
5. Center sash protector
6. Stationary window glass and weatherstrip
7. Door glass holder
8. Door glass pad
9. Door window glass
10. Door glass slider
11. Window regulator

NOTES:
1. Reverse the removal procedures t6 reinstall.
2. * Vehicles with a power window

SERVICE POINTS OF REMOVAL





2. Removal Of Outer Weatherstrip
Use a screwdriver or similar tool to remove the outer weatherstrip.





9. Removal Of Door Window Glass
1. After removing the door window glass mounting bolts, lower the door window glass to the lower pant of the door panel.
2. Remove the glass holder from the regulator.
3. Remove the door glass by lifting it upward.

11. Removal Of Window Regulator





Vehicles without a Power Window
1. Remove the window regulator mounting bolts.

NOTE: Hold the regulator assembly so that it does not drop off when bolts are removed.

2. Take out the window regulator through the access hole.





Vehicles with a Power Window
1. Remove the regulator mounting bolts, and then remove the regulator from the access hole.
2. Disconnect the power window motor from the regulator.

CAUTION: Because the force of the regulator spring may cause the regulator arm to lump up when the screws attaching the motor to the window regulator are removed, remove the regulator spring before removing the screws.

SERVICE POINTS OF INSTALLATION





11. Installation Of Window Regulator
Vehicles without a Power Window
Apply a coating of chassis grease to the sliding parts and rotating parts of the window regulator.





Vehicles with a Power Window
When assembling the window regulator and power window motor, first install the regulator spring, and then proceed with assembly.





9. Installation Of Door Window Glass
When the door glass has been removed from the glass holder, install to the position shown in the illustration.

Standard value: 44-50 mm (1.73-1.97 in.)





5. Application Of Sealant To Center Sash Protector
Apply the specified sealant to the center sash protector at the Position shown in the illustration, and then install the center sash protector.

Specified sealant: MOPAR K-1O1 Cement Part No. 3837969 or equivalent