Seat Belt: Service and Repair

FRONT SEAT BELT REMOVAL STEPS
1. Buckle stalk
2. Center pillar trim, lower
3. Sash guide cover
4. Front seat belt assembly





REAR SEAT BELT REMOVAL STEPS
5. Lower quarter trim
6. Rear seat cushion
7. Rear seat belt assembly

SERVICE POINTS OF REMOVAL





1. Removal Of Buckle Stalk
Remove the floor console mounting screws shown in the illustration. Raise the floor console slightly to remove the buckle stalk mounting bolt.

NOTE: When the buckle stalk on the driver's side is removed, disconnect the seat belt switch.


SERVICE POINTS OF INSTALLATION
7. Installation Of Rear Seat Belt Assembly





1. Install the anchor plate so that it conforms to the floor bead.





2. install the belt by passing it through the slit in the seat cushion when the seat is installed.





3. Install the rear seat belt by inserting the retractor locking claw positively in the hole made in the body.





4. Installation Of Front Seat Belt Assembly
Install the front seat belt by inserting the retractor locking tab positively in the hole made in the body.