Sliding Force of the Motor's Clutch

SLIDING FORCE OF THE MOTOR'S CLUTCH





1. insert one end of an allen wrench (provided in the tool bag) into the motor gear hole and hook a spring scale to the other end, and measure the force when the clutch starts to slip (when the alien wrench begins to turn).

Standard value: 35-44 N (8-10 ft. lbs.)

CAUTION: Pull the spring scale in a direction at right angles to the wrench. Note that if a wrench other than the one provided in the tool bag is used, the measured value may not coincide with the standard value.





2. If the sliding force of the motor's clutch is not within the standard value range, adjust by following one or the other of the procedures described below.

a. Adjust the tightening torque of the bolt within the tightening torque range indicated in the illustration.
b. Remove the bolt and reduce the number of shims.