Rear Door Window Regulator

Rear Door Window Regulator - Manual:

MANUAL WINDOW REGULATOR
1. Remove trim panel, silencer pad, and water shield.
2. Position door glass 150 mm (6 in.) up into glass opening. Pull upward firmly at front edge of glass to disengage lower glass run guide from division channel.
3. Remove bolts bolding window regulator to inner door panel.
4. Slide roller from window lift channel.
5. By hand, pull glass upward to 25 mm (1 in.) from full up position. Using suitable tape, secure door glass to upper window frame.
6. Remove regulator assembly from door.
7. Reverse the preceding operation for installation.

Rear Door Window Regulator - Power:

POWER WINDOW REGULATOR
1. Remove trim pane], silencer pad, and water shield.
2. Position door glass 150 mm (6 in.) up into glass opening. Firmly pull upward at front edge of glass to disengage lower glass run guide from division channel.
3. Remove bolts holding window regulator to inner door panel.
4. Slide roller from window lift channel.
5. By hand, pull glass upward to 25 mm (1 in.) from full up position. Using suitable tape, secure door glass to upper window frame.
6. Remove regulator assembly from door.
7. Reverse the preceding operation for installation.