Replacement

NOTE: The low tire pressure warning module is mounted to the instrument panel just above the steering column and behind the instrument panel upper cover.





REMOVE
1. Remove the top cover from the instrument panel. The top cover is removed by pulling it straight rearward by hand to disengage the retaining clips from the lower instrument panel.





2. Remove wiring harness from low tire pressure warning module.
3. Remove screw, mounting upper bracket on low tire pressure warning module to the instrument panel.
4. Remove screw, mounting lower bracket on low tire pressure warning module to the instrument panel.
5. Remove low tire pressure warning module from instrument panel.

INSTALL
1. Install low tire pressure warning module on instrument panel.
2. Install and securely tighten the screw mounting upper bracket on warning module to instrument panel.
3. Securely tighten the screw mounting lower bracket on warning module to instrument panel.
4. Install wiring harness connector on warning module.
5. Program the identification code from each tire pressure transmitter into the new low tire pressure warning module. This is done using the DRB III scan tool.
6. Verify that the receiver has been programmed with the identification code from all four of the tire pressure transmitters. Use the DRB III scan tool to look at the receiver's memory for an identification code and the tire pressure value from each tire pressure sensor/transmitter. If these are present in the receivers memory the receiver has been correctly programmed.
7. Install the top cover on the instrument panel. Top cover is installed using the reverse order of its removal.
8. Road test the vehicle to verify the proper function of the low tire pressure warning system.