Rear

Inspect the stabilizer bar attaching links for any of the conditions which are listed below. If any of these conditions are found when inspecting the stabilizer bar links, the link will require replacement. Do not attempt to repair a stabilizer bar attaching link.
- Inspect the attaching links for any bending of the center section of the link.
- Inspect the attaching link bushings for end play or excessive looseness. If any of these conditions are found the attaching link will need to be replaced.
- Check the attaching link mounting points at the stabilizer bar and lower control arm to be sure the mounting nuts are tight. If required tighten the nuts to the specified torque.