Transmission Fluid Cooler Hose/Pipe Connector Replacement

Transmission Fluid Cooler Hose/Pipe Connector Replacement

Removal Procedure





Notice: Allow sufficient clearance around the transaxle oil cooler pipes and around the hoses to prevent damage or wear which may cause fluid loss.

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Position a drain pan under the vehicle.
3. Remove the oil cooler hoses from the transaxle oil cooler fittings. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement.
4. Remove the oil cooler fittings (28, 29) from the transaxle.

Installation Procedure





Notice: Refer to Fastener Notice.

Important: The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.

1. Install the oil cooler fittings (28, 29) to the transaxle.

Tighten the fittings to 38 N.m (28 lb ft).

2. Install the oil cooler hoses to the transaxle oil cooler fittings. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement.
3. Lower the vehicle.

Notice: Refer to Transmission Overfill Notice.

4. Adjust the fluid level.
5. Inspect for fluid leaks. Refer to Fluid Leak Diagnosis.
6. Remove the drain pan from under the vehicle.