Power Steering Reservoir Inlet Pipe/Hose Replacement (LY7, Power Steering Pump to Reservoir)

Power Steering Reservoir Inlet Pipe/Hose Replacement (LY7, Power Steering Pump to Reservoir)

Removal Procedure




1. Compress the clamp (1) and disconnect the power steering reservoir inlet hose (2) from the power steering fluid reservoir (3).
2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
3. Remove the RH front tire and wheel assembly.




4. Compress the clamp (1) and disconnect the power steering reservoir inlet hose (2) from the power steering pump (3).
5. Remove the power steering reservoir inlet hose from the vehicle.

Installation Procedure

1. Position the power steering reservoir inlet hose to the vehicle.




2. Compress the clamp (1) and connect the power steering reservoir inlet pipe (2) to the power steering pump (3).
3. Install the RH front tire and wheel assembly.
4. Lower the vehicle.




5. Compress the clamp (1) and connect the power steering reservoir inlet hose (2) to the power steering fluid reservoir (3).
6. Fill and bleed the power steering system. Refer to Power Steering System Bleeding.