Brake Proportioning/Combination Valve: Service and Repair

Proportioning Valve Replacement (Non-ABS)

Removal Procedure




Caution: Refer to Brake Fluid Irritant Caution.

Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice.

1. Clean the outside of the reservoir and the reservoir cap (4).
2. Remove the reservoir cap.
3. Remove the reservoir diaphragm.
4. Remove the brake fluid with a syringe.




5. Clean the proportioning valve (7) and the brake pipes.
6. Remove the 5 brake pipes from the proportioning valve.
7. Remove the 2 bolts (5, 6).
8. Remove the proportioning valve.

Installation Procedure





Notice: Refer to Fastener Notice.

1. Install the proportioning valve (7) and the 2 bolts (5, 6) to the cowl.

Tighten the bolts to 5.4 N.m (47.79 lb in).

2. Install the brake pipes to the proportioning valve.
3. Tighten the flare nuts (1, 2, 3, 4, 8)

Tighten the flare nuts to 15.2 N.m (11.2 lb ft).

4. Bleed the hydraulic brake system.