Parking Brake Lever: Service and Repair

Park Brake Lever Assembly Replacement

Removal Procedure

1. Remove the rear floor console.

Parking Brake:

2. Disconnect the park brake switch electrical connector (10).
3. Remove the upper park brake front cable nut (2).
4. Remove the lower park brake front cable nut (3).
5. Remove the 2 bolts (4, 11).
6. Remove the lever (1).
7. Unfasten the tab in order to remove the park brake front cable (9) from the lever.
8. Remove the screw (12) from the park brake switch.
9. Remove the park brake switch (5).

Installation Procedure

Parking Brake:

1. Install the park brake switch (5) to the park brake lever.
2. Install the screw (12) to the park brake switch.
3. Install the park brake front cable (9) to the lever.
4. Fasten the tab.
5. Install the lower nut (3).
6. Install the upper nut (2).
7. Install the park brake lever to the floor of the vehicle.

Notice: Refer to Fastener Notice.

8. Install the 2 bolts (4, 11).

Tighten the bolts to 12.5 N.m (110.6 lb in).

9. Connect the park brake switch electrical connector (10).
10. Adjust the park brake lever.
11. Install the rear floor console.