Roof Retractable Panel Stowage Compartment Lid Cylinder Replacement - Rear Lower

Roof Retractable Panel Stowage Compartment Lid Cylinder Replacement - Rear Lower

Removal Procedure

Caution: Refer to Eye Protection Caution.

Caution: Refer to Folding Top Hydraulic Pressure Caution.

Caution: Refer to Servicing Electrical Components Caution.

Notice: Refer to Cylinder Hoses Notice.

1. Remove the rear compartment side trim panel.
2. Remove the rear compartment sill trim panel.
3. Remove the center hydraulic cylinder pin and clip.




4. Remove the lock clips (1) and pins (2) from each side of the module.




5. Open the folding top module.
Pull upward and push forward to open.




6. Remove the retractable hydraulic compartment lid cylinder (2) from the module (1).
7. Using a suitable tool, remove the ball socket ends from the assembly:

1. Release the hydraulic pump pressure. Refer to Folding Top Pump Bypass Valve Pressure Release Adjustment.
2. Use a small flat-bladed tool to lift the retainer spring flex clip.
3. Do not reuse spring flex clip. Replace spring flex clip after disassembly.
4. Before disconnecting the cylinder hoses, have the replacement cylinder ready.
5. Once the cylinder hose or the port plug has been removed, DO NOT move the cylinder rod. This will cause fluid to squirt out of the ports.

8. Remove the hydraulic compartment lid cylinder from the vehicle.

Installation Procedure

1. Install the hydraulic compartment lid cylinders to the vehicle.
2. Connect the hydraulic lines to the retractable hydraulic compartment lid cylinders:

1. Install new O-rings to the cylinder hoses.
2. Install the hoses into the cylinder ports. Press down on the hoses until the hoses are fully seated into the cylinder.
3. Install new cylinder hose flex clips.
4. Inspect the flex clips to ensure that the clips are fully seated around the hoses.




3. Install the retractable hydraulic compartment lid cylinder (2) to the module (1).
4. Install the ball socket ends to the assembly.




5. Pull upward and then pull rearward to lock in place.
6. Install the center hydraulic cylinder pin and clip.




7. Install the lock pins (2) and the clips (1) to each side of the module.
8. Tighten the hydraulic pump bypass valve. Refer to Folding Top Pump Bypass Valve Pressure Release Adjustment.
9. Inspect the fluid level and add fluid as needed.
10. Inspect the folding top for proper operation.
11. Install the rear compartment trim panel.
12. Install the rear compartment side trim panel.