Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust

Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust

Removal Procedure


Important: Do not disconnect the power steering fluid lines/hoses from the reservoir.


1. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access. Refer to Power Steering Fluid Reservoir Replacement (3.6L Engine) (Power Steering Fluid Reservoir Replacement (3.6L Engine))Power Steering Fluid Reservoir Replacement (6.0L Engine) (Power Steering Fluid Reservoir Replacement (6.0L Engine)) .




2. Remove the camshaft position (CMP) sensor electrical connector (1) from the CMP sensor (2).




3. Remove the CMP sensor to engine front cover retaining bolt (1).
4. Remove the CMP sensor (2) from the engine front cover.



Installation Procedure





1. Install the CMP sensor to the engine front cover.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the CMP sensor to engine front cover retaining bolt (1).

Tighten the bolt to 10 N.m (89 lb in).





3. Install the CMP sensor electrical connector (1) to the CMP sensor (2).
4. Install the power steering fluid reservoir. Refer to Power Steering Fluid Reservoir Replacement (3.6L Engine) (Power Steering Fluid Reservoir Replacement (3.6L Engine))Power Steering Fluid Reservoir Replacement (6.0L Engine) (Power Steering Fluid Reservoir Replacement (6.0L Engine)) .