Adjust Link Outer Bushing Replacement

Adjust Link Outer Bushing Replacement

Tools Required

KM-906-B Control Arm Bushing Remover/Installer.


Removal Procedure

Caution: Refer to Safety Glasses Caution (Safety Glasses Warning) .
Caution: Refer to Vehicle Lifting Caution (Service Precautions) .
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
2. Remove the I-Link. Refer to Adjust Link Replacement (Rear Suspension) .





Important: It is recommended to observe the orientation and depth of the I-Link outer bushing (3) with reference to the original position. Adhering to this recommendation will minimize the potential of incorrect I-Link outer bushing (3) installation.


3. Remove the I-Link outer bushing (3) from the I-Link (2) using the KM-906-B (1, 4).
4. Inspect all parts for wear and damage.



Installation Procedure






Important: The I-Link bushing must be centred in the I-Link.


1. Install the I-Link outer bushing (2) using the KM-906-B (1, 4).
2. Install the I-Link (3). Refer to Adjust Link Replacement (Rear Suspension) .
3. Remove the safety stands.
4. Lower the vehicle to the ground.