3. Crankshaft Balancer Removal

Crankshaft Balancer Removal

Removal Procedure


Tools Required
* J 41816 Crankshaft Balancer Remover
* J 41816-2 Crankshaft End Protector
* J 42386-A Flywheel Holding Tool






1. Remove the right transmission cover (1) to engine oil pan retaining bolt (2).
2. Remove the right transmission cover (1).





Notice: Refer to Fastener Notice (Fastener Notice) .

3. Using the two starter motor bolts (2), install the J 42386-A (1).

Tighten the bolts to 50 N.m(37 lb ft).






Important: DO NOT discard the crankshaft balancer bolt. The balancer bolt will be used during the first pass only of the balancer installation procedure. Install a NEW crankshaft balancer bolt at second pass, during final assembly.


4. Remove the crankshaft balancer retaining bolt (1).




5. Use the J 41816 (1) and J 41816-2 (2) to remove the crankshaft balancer (3).