Turn Signal Flasher: Service and Repair

Hazard and Turn Signal Flasher Replacement

The turn/hazard signal relay is located in the Junction Block behind the IP storage compartment tray.


Removal Procedure





1. Remove the IP storage compartment tray. Refer to Instrument Panel Storage Compartment Replacement (Service and Repair).
2. Remove the turn/hazard signal relay (1) from the Junction Block.



Installation Procedure





1. Install the turn/hazard signal relay (1) to the Junction Block.
2. Install the IP storage compartment tray. Refer to Instrument Panel Storage Compartment Replacement (Service and Repair).