42. Camshaft Removal - Right Side

Camshaft Removal - Right Side





Important: EN 46105 (1) was installed to the camshafts (2) as part of the right bank cylinder head camshaft position actuator removal procedure.


1. Remove the EN 46105 (1) from the right bank camshafts (2).
2. Position the camshaft lobes in a neutral position.




3. Observe the markings (1) on the bearing caps. Each bearing cap is marked in order to identify its location. The markings have the following meanings:

* The raised feature must always be oriented toward the center of the cylinder head.
* The I indicates the intake camshaft.
* The E indicates the exhaust camshaft.
* The number indicates the journal position from the front of the cylinder block.




4. Remove the camshaft bearing cap to cylinder head retaining bolts (1).
5. Remove the camshaft bearing caps (2).




6. Remove the camshafts (1).