Repeater Lamp Replacement

Repeater Lamp Replacement

Removal Procedure - Side Indicator Type A

Warning: Refer to Battery Disconnect Warning (Battery Disconnect Warning).

1. Disconnect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (Service and Repair).




2. Remove side indicator lamp assembly from the fender by grasping the assembly and pushing the assembly forward to disengage the rear clip from the fender.
3. Tilt the rear of the side indicator lamp assembly out and remove the assembly from the front fender.
4. Disconnect the bulb socket from the side indicator lamp assembly by rotating the socket counterclockwise.
5. Disconnect the electrical connector from the bulb socket, by depressing the connector clip and pulling connector from bulb socket.
6. Discard the repeater lamp.

Installation Procedure - Side Indicator Type A




1. Install the bulb socket into the new side indicator lamp assembly and rotate the socket clockwise to secure the bulb.
2. Connect electrical connector to the bulb socket, note oretayion of the electrical connector.
3. Install rear portion of the side indicator lamp assembly into the fender and then push the front of the lamp assembly inwards to engage the front clip.
Warning: Refer to Battery Disconnect Warning (Battery Disconnect Warning).

4. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (Service and Repair).
5. Check all vehicle lights for correct operation.