Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust

Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust

Removal Procedure

Note: Do not disconnect the power steering fluid lines/hoses from the reservoir.

1. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access. Refer to Power Steering Fluid Reservoir Replacement (3.6L Engine) (Service and Repair)Power Steering Fluid Reservoir Replacement (6.0L Engine) (Service and Repair).




2. Remove the camshaft position (CMP) sensor electrical connector (1) from the CMP sensor (2).




3. Remove the CMP sensor to engine front cover retaining bolt (1).
4. Remove the CMP sensor (2) from the engine front cover.

Installation Procedure




1. Install the CMP sensor to the engine front cover.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the CMP sensor to engine front cover retaining bolt (1) and tighten to 10 Nm (89 lb in).




3. Install the CMP sensor electrical connector (1) to the CMP sensor (2).
4. Install the power steering fluid reservoir. Refer to Power Steering Fluid Reservoir Replacement (3.6L Engine) (Service and Repair)Power Steering Fluid Reservoir Replacement (6.0L Engine) (Service and Repair).