5L40-E/5L50-E - Automatic Transmission

Shift Control Linkage Adjustment

1. Position the shift lever in PARK.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




3. Loosen the shift control linkage adjustment bolt to allow the adjuster (1) to slide freely.
Caution: Refer to Fastener Caution (Fastener Caution).

4. Hold the selector lever on the transmission against the rear stop to eliminate any play. Tighten the shift control linkage adjustment nut 9 Nm (80 lb. in).
5. Lower the vehicle.




6. Check the operation of the starting system with the shift lever in each position. The engine should only crank when the lever is in the PARK or NEUTRAL position.