Output Carrier Assembly Installation

Output Carrier Assembly Installation





Note: Engage all the discs of the 4th clutch and the hub splines of the output carrier and assemble them securely.

1. Install the output carrier assembly to the transmission case.





Note: Make a note of dimension E as it is necessary for the following process.

2. Using a straightedge and vernier calipers, measure the gap between the top of the differential drive pinion in the output carrier assembly and contact surface of the transaxle and housing (Dimension E).





Note: Make a note of dimension E as it is necessary for the following process.

3. Measure two places on the transaxle housing. Calculate the dimension E using the formula.
Dimension E = Dimension A - Dimension B




4. Install the bearing race to the transaxle while checking its direction.

* Standard inside bearing race diameter - 34.5 mm (1.358 in)
* Standard outside bearing race diameter - 48.5 mm (1.909 in)