Crankshaft Main Bearing

MAIN BEARING CAP




Crankshaft Bearing Cap to Cylinder Block
1st 40 Nm (30 lb ft)
2nd Turn 90 degrees

CRANKSHAFT

Standard Main Bearing Center Wall Thickness
Mark 1 1.994-1.997 mm (0.0785-0.0786 in)
Mark 2 1.998-2.000 mm (0.0787-0.0787 in)
Mark 3 2.001-2.003 mm (0.0788-0.0789 in)
Mark 4 2.004-2.006 mm (0.0789-0.0790 in)
Maximum Circle Runout 0.03 mm (0.0012 in)
Standard Oil Clearance 0.016-0.039 mm (0.0006-0.0015 in)
Maximum Oil Clearance 0.050 mm (0.0020 in)
Crank Pin Diameter 43.992-44.000 mm (1.7320-1.7323 in)
Maximum Taper and Distortion 0.004 mm (0.0002 in)

Crankshaft Bearing
Dimension A 0.5-1.0 mm (0.020-0.039 in)
Dimension A-B 0.5 mm (or less 0.0197 in or less)

Crankshaft Bearing Cap Set Bolt
Standard Diameter 84.3-85.7 mm (3.3189-3.3740 in)
Minimum Diameter 86.7 mm (3.4134 in)