964619 Removing and installing reading light

WM 964619 Removing and installing reading light

Removing reading light

Information

Some of the repair illustrations show only one side of the vehicle. Naturally, some steps also have to be performed on the opposite side of the vehicle as well. These must be carried out as a mirror image of the steps shown.





Installation position of reading lights

1. Unclip the reading light using a plastic wedge -A- and remove it -B-.





Unclipping reading light

2. Release plug connection -a- and pull it off -A-.





Disconnecting plug connection

Installing reading light

Information

Some of the repair illustrations show only one side of the vehicle. Naturally, some steps also have to be performed on the opposite side of the vehicle as well. These must be carried out as a mirror image of the steps shown.

1. Connect plug connection until it engages securely.





Connecting plug connection

2. Fit reading light -A- and clip it in -B-.





Installing reading light

Replacing light bulb for reading light

NOTICE

Incorrect handling of bulbs

- Risk of damage to bulbs and the bulb housing

-> Switch off ignition and remove ignition key.
-> Switch off the relevant loads when changing bulbs.
-> Only use bulbs listed in the bulb table.
-> Only install clean bulbs that are free of grease.
-> Always use a cloth or soft paper when working with bulbs.
-> Observe the safety instructions when changing a bulb in a Bi-Xenon headlight.
-> In certain states, it is compulsory to carry spare light bulbs.

Information

Some of the repair illustrations show only one side of the vehicle. Naturally, some steps also have to be performed on the opposite side of the vehicle as well. These must be carried out as a mirror image of the steps shown.

1. Release the light bulb holder by turning it.





Removing holder

2. Remove light bulb.





Removing light bulb

3. Insert the light bulb.





Inserting light bulb

4. Insert the holder and lock it by turning it.





Installing holder