Fitting Protective Plate - 5th Bow Motor RH Side

SUBJECT # 5:
FITTING PROTECTIVE PLATE BY 5TH BOW MOTOR, RH SIDE

APPLICATION:
VIN SERIAL NOS. S7000216-S7012964




Figures 6A, 6B, 6C

Fit a protective plate by the 5th bow motor on the right hand side to eliminate the risk of the toothed segment damaging the wiring connected to the 5th bow's potentiometer.

Parts:

Protective plate 45 59 951
Screw (if necessary) 45 55 710
Loctite ThreadLocking Adhesive

1. Operate the top using the "ROOF" switch until it is halfway raised and the Tonneau cover is fully upright. All windows should be lowered.

2. Remove the two lower screws securing the 5th bow motor. See Figure 6.A.

3. Apply Loctite to the screw threads. See Figure 6.B.

4. Fit the protective plate in position and tighten the screws. See Figure 6.C.

Tightening torque: 10 Nm (84-96 in.lbs.).