Heater Housing, Installation

1. Position the heater box in place.
2. Check that the 0-rings are in place and that they are undamaged. Refit the hoses and secure them with the clips.
3. Close the heater-box housing enclosure.
4. Refit the rear air ducts on the floor and secure them with a cable tie. Carry out the following operations:
- Refit the center console.
- Refit the ACC control unit.
- Refit the switches for the window lifts.
- Refit the rear part of the center console.
- Refit the rear air vent and cover.
- Refit the rear ashtray.
- Refit the cover round the ignition switch.
- Refit the panels on both sides of the centre console.
- Refit the glove box.





5. Refit the coolant hoses on the heater box and tighten the hose clips.
6. Fill up with coolant.
7. Bleed the system as follows:
- Fill the system to the MAX level, refit the pressure cap, start the engine and warm it up, preferably at varying speeds, until the radiator fan cuts in.
- Remove the pressure cap and top up to the MAX mark.
- Refit the pressure cap and run the engine at varying speeds until the radiator fan cuts in three more times. Switch off the engine and top up to the MAX level as necessary.