Front Seat Belt

Front Seat Belt

Removal

Outer Seat Belt Assembly
Turn the ignition switch to OFF, disconnect the ground cable from battery, and wait for more than 20 seconds.
Fold backrest all the way forward, and then move front seat all the way forward.
Remove the center pillar lower trim.
Remove the anchor cover. Loosen the shoulder anchor bolt, and then detach the shoulder anchor from center pillar.







Turn over the floor mat to disconnect the connector (A) of pretensioner, and then loosen the three bolts to remove the outer seat belt assembly.







Remove the center pillar upper trim.
Remove the two bolts and adjustable anchor assembly.







IMPORTANT
- Do not drop or apply any impact to the pretensioner.
- Pretensioner and bracket should be treated as an assembly. Do not attempt to disassemble it.

Inner Seat Belt Assembly
Turn the ignition switch to OFF, disconnect the ground cable from battery, and wait for more than 20 seconds before starting work.
Remove the console box.
Disconnect the seat belt warning light connector under the seat.
Remove the clip of harness from seat rail.
Remove the anchor bolt, and then remove the inner seat belt assembly.







Installation

Outer Seat Belt Assembly
Install in the reverse order of removal.

IMPORTANT
- Parts of the driver and passenger sides are not identical. Before installation, make sure the correct part is used.
- Be careful not to twist the seat belts during installation.

Tightening torque:
T: 30 Nm (3.1 kgf-m, 22 ft-lb)

Inner Seat Belt Assembly
Install in the reverse order of removal.

Tightening torque:
T: 30 Nm (3.1 kgf-m, 22 ft-lb)