Switches and Harness

Switches And Harness
REMOVAL
BACK-UP LIGHT AND NEUTRAL POSITION SWITCH
Disconnect the ground cable from battery.
Remove the intercooler.





Disconnect the connector of back-up light switch and neutral position switch.
Lift-up the vehicle.




(A) Neutral switch (Brown)
(B) Back-up light switch (Gray)

Remove the back-up light switch and neutral position switch with harness.

INSTALLATION
BACK-UP LIGHT SWITCH AND NEUTRAL POSITION SWITCH




(A) Neutral switch
(B) Back-up light switch

Install the back-up light switch and neutral position switch with harness.
Tightening torque: 32.3 Nm (3.3 (kgf-m, 23.8 ft. lbs.)

Connect the connector of back-up light switch and neutral position switch.
Install the intercooler.
Connect the battery ground cable to battery.

INSPECTION
BACK-UP LIGHT SWITCH
Inspect the back-up light switch.

NEUTRAL POSITION SWITCH
Turn the ignition switch to OFF.
Disconnect the connector of neutral position switch.








Measure the resistance between neutral position switch terminals.
Replace defective parts.